Gamber-Johnson CLEVIS 0-90T Manuel d'installation télécharger pdf (Page 2)

If you need assistance or have questions, call Gamber Johnson at 1-800-456-6868.

MCS-CLEVIS

MCS Clevis

1. To obtain side-to-side swivel motion the MCS-Clevis must be mounted on equipment with a pattern of (3) in-line

holes, as the swivel pattern cutout is part of the clevis. (MCS Clevis Base shown in illustration).

2. The clevis assembly is typically mounted with the tilt lock knob on the right side as you face it. Unscrew the tilt

knob to loosen the assembly and set the amount of tilt. Lock in place by tightening knob.

3. The MCS-Clevis is supplied with (3) .25-20 x 1.00 carriage bolts (item 5), (2) nylon bearings (item 3), (1) backup

plate (item 4), (3) .25 flat washers (item 6) and (3) .25 lock nuts (item 7).

4. To mount, place clevis assembly (item 1) on MCS Clevis Base (item 2), with (1) nylon bearing (item 3) in-

between.

5. On the top side of the MCS-Clevis place (1) nylon bearing (item 3) and (1) backup plate (item 4). Install (3) .25-20 x

1.00 carriage bolts (item 5), through the three square holes in backup plate & nylon bearings, through center hole and

slots in clevis assembly and MCS Clevis Base as shown in illustration.

(Note: to have the proper swivel motion, parts need to be assembled in the correct order, metal-nylon-metal.)

6. Hold parts in place by adding (3) .25 flat washers (item 6) and (3) .25 lock nuts (item 7).

7. Adjust drag on the swivel motion by tightening the (3) lock nuts as required.

1 2

Pas de commentaire

Gamber-Johnson CLEVIS 0-90T Manuel d'installation Page 2